Screwed Gamers Homepage

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[V8SC] Stewards Briefing - Round 3
#1
Round 3, Bernese Alps, Stewards Briefing
May 5th, 2016

Teams and drivers are advised of the following information contained within:
Qualifying Procedure
Starting Procedure
Pit Entry and Exit


All information contained in this stewards briefing is created with the purpose of ensuring we have stable events, so CANZ administrators appreciate that everyone follows this information along with adhering to the CANZ sporting regulations.

Qualifying Procedure:
Qualifying for Round 2 of the CANZ V8 Supercars series will be a timed session of 15 minutes. No shootout session or group split will be required for this circuit. Please spread yourselves out on circuit to avoid dirtying others laps through drafting.

Starting Procedure:
For the first race, a standard start will be used. Should a reverse grid race be run, a standing manual start will be used to set grid positions.

Pit Entry and Exit:
Please observe the following images:
[Image: rfPm33K.png]

[Image: zkzDkOq.png]

For pit entry, please communicate early that you will be entering the pits as it does require slightly earlier breaking into the final corner. You must remain inside the yellow line as picture, aborted pitstops due to crossing this line may be deemed a corner cut if a collision occurs. As always you cannot pit at the end of the first lap unless you have damage, and you must not pit on the last lap and finish the race in the pit lane.

For pit exit, remember to communincate that you are exiting the pits as you feed towards the inside line on turn 1 for a particularly high speed corner, remain inside the yellow line and do not aggressively cross onto the racing line.

Any questions, pop them below, otherwise I'll see you all tomorrow night and let's have a good race to start the season!
[Image: signature_S5.png]

(╯°□°)╯︵ ┻━┻
Reply


Messages In This Thread
[V8SC] Stewards Briefing - Round 3 - by Scav3nger - 05-05-2016, 10:36 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)